Start by placing the loop/knot through the center hole (from top through to bottom) and secure each of the seven individual strings into slots (leaving the slot closest to you empty)
1. Move string from position 2 to position 5 (skipping two slots)
2. Rotate disc clockwise so that position 2 (now empty) is closest to you
3. Move string from position 7 to position 2 (skipping two slots)
4. Continue this pattern until bracelet is desired length.
2. Rotate disc clockwise so that position 2 (now empty) is closest to you
3. Move string from position 7 to position 2 (skipping two slots)
4. Continue this pattern until bracelet is desired length.
TIP: Keep non-dominant thumb lightly pressed over the center hole (where the collection of string comes out of). This helps keep everything taut throughout the process.
TIP: Stretch bracelet before approaching desired length as this will lengthen it quite a bit.
NOTE: These instructions are set for those who are right hand dominant.
Simply reverse to counter clockwise if you are left hand dominant.
Simply reverse to counter clockwise if you are left hand dominant.
